Hookless rims and tyre pressure: what is allowed and what is not?
More and more wheelsets come with hookless rims. That has advantages, but also rules you need to know. And it raises a question many riders have: what tyre pressure is actually right?
What is a hookless rim?
A classic rim has a small bead hook on the inside that holds the tyre bead in place. On a hookless rim that hook is absent: the wall runs straight up. The tyre stays put through pressure and because the bead sits tight against the rim shoulder. Manufacturers choose hookless because the rim can be made stronger and to tighter tolerances, and is less prone to damage at the edge.
The rules at a glance
- 5 bar maximum
- Under the international standard, pressure on hookless rims may not exceed 5 bar (72.5 psi). Some wheel manufacturers set an even lower limit per tyre width.
- Approved tyres only
- Only use tubeless tyres that the tyre or wheel manufacturer has explicitly approved for hookless. Wheel brands such as Zipp and Enve publish compatibility lists.
- Minimum tyre width
- A minimum width applies, depending on the internal width of the rim. On the Zipp 303 Firecrest (25 mm internal) that is 28 mm; on the Enve SES 4.5, 27 mm.
- An inner tube is not a free pass
- An inner tube works as a roadside fix, but the pressure limit still applies.
Hookless or hooked: what do you notice?
If you ride road tyres of 28 mm or wider, you will notice little of the restriction in practice: the right pressure sits below 5 bar for most riders. If you are heavy, or like narrower tyres at high pressure, a hooked rim gives you more freedom. The Roval Rapide CLX III allows up to 7.6 bar tubeless, the Scope Artech 4 up to 8.6 bar.
How do you choose the right tyre pressure?
The right pressure depends on your weight (bike included), the tyre width, the internal width of your rim and the surface. Wider tyres run lower pressures. Lower is not always slower: on rough tarmac and brick paving a tyre at slightly lower pressure often rolls faster, because it bounces less.
As a starting point: a rider of around 75 kilos on 28 mm tubeless tyres usually lands around 4.5 to 5.5 bar with the major manufacturers' calculators, and no more than 5 bar on hookless rims. On 40 mm gravel tyres that is around 2 to 2.8 bar, depending on the surface. Use your tyre or rim manufacturer's calculator and fine-tune by feel from there.
Common mistakes
- Inflating to the maximum on the sidewall
- That figure is an upper limit, not a recommendation. On hookless rims the rim limit applies as well.
- Too narrow a tyre on a wide rim
- That gives a poor tyre shape and can be unsafe on hookless rims.
- Not checking pressure
- Tubeless tyres lose air slowly. Check the pressure before every ride.
Further reading
See our top lists of wheelsets and bike tyres; every wheelset lists the rim type, the maximum pressure and the tyre widths.